Downloads > External Modem Settings
Attaching an External Modem to a Prilink base unit:
An external modem can be attached to the COM port of a Prilink base unit to allow remote dial-up access from PrilinkII software. Although any modem brand may be used, Prilink recommends a US Robotics V.92 modem with the following dip switch settings (correct position for each switch is highlighted in green):
| Dip Switch Settings | ||
| 1 | UP | Data Terminal Ready normal |
| DOWN | Data Terminal Ready override | |
| 2 | UP | Verbal result codes |
| DOWN | Numeric result codes | |
| 3 | UP | Suppress result codes |
| DOWN | Display result codes | |
| 4 | UP | Echo offline commands |
| DOWN | No echo, offline commands | |
| 5 | UP | Auto answer on first ring, or higher if specified in NVRAM |
| DOWN | Auto answer off | |
| 6 | UP | Carrier detect normal |
| DOWN | Carrier detect override | |
| 7 | UP | Load NVRAM defaults |
| DOWN | Load factory defaults | |
| 8 | UP | Dumb mode |
| DOWN | Smart mode | |
Quick Links
Contact
- Have questions about Prilink?
- Please call us at
- 905-882-4488 or
- 1-866-261-0649
- or E-mail us
- Sales Enquires
- Sales@prilink.com
- Technical Support
- Support@prilink.com